Diameter Reduction Procedure Problem A cylindrical rod of brass originally 10 mm ( 0.39 in ) in diameter is to be cold worked by drawing. The circular cross section will be maintained during deformation. A cold-worked tensile strength in excess of 380 MPa (
55,000\psi
) and a ductility of at least 15 %EL are desired. Furthermore, the final diameter must be
7.5\deg mm
( 0.30 in ). Explain how this may be accomplished.

Question

Diameter Reduction Procedure Problem A cylindrical rod of brass originally 10 mm ( 0.39 in ) in diameter is to be cold worked by drawing. The circular cross section will be maintained during deformation. A cold-worked tensile strength in excess of 380 MPa (

55,000\psi

) and a ductility of at least 15 %EL are desired. Furthermore, the final diameter must be

7.5\deg mm

( 0.30 in ). Explain how this may be accomplished.

student submitted image, transcription available below

Accepted Answer

Expert Answer to - Diameter Reduction Procedure Problem A cylindrical rod of brass originally 10 mm ( 0.39 in ) in diam

Answer

Solution for - Diameter Reduction Procedure Problem A cylindrical rod of brass originally 10 mm ( 0.39 in ) in diam

Answer

This an additional answer to - Diameter Reduction Procedure Problem A cylindrical rod of brass originally 10 mm ( 0.39 in ) in diam

(Solved): Diameter Reduction Procedure Problem A cylindrical rod of brass originally 10 mm ( 0.39 in ) in diam ...

View Expert Answer

Expert Answer

Buy This Answer $5

Place Order